> >>Hyper Speed hotend Raise3D (Pro 3 series)
Hyper Speed hotend Raise3D (Pro 3 series) View larger

Hyper Speed hotend Raise3D (Pro 3 series)

Raise3D

New product

139,00 €
139,00 €

Ask for information

High-flowrate hotend designed for the Pro3 Series on Hyper Speed Mode.

Add to wishlist

The Hyper Speed hotend was developed by Raise3D especially for the Hyper Speed printing mode for the Pro3 and Pro 3 Plus 3D printers. The Hyper Speed mode makes it possible to achieve higher printing speeds with the Raise3D Premium filaments (100-150 mm/s) and print at speeds of up to 300 mm/s with the Raise3D Hyper Speed filaments, Hyper Speed PLA and Hyper Speed ABS.

The Hyper Speed hotends installed on the Pro 3 Plus 3D printer

Image 1: The Hyper Speed hotends installed on the Pro 3 Plus 3D printer. Source: Raise3D.

The Hyper Speed hotend comes with a 0.4 mm nozzle and is compatible with 1.75 mm filament. It must be kept in mind that the Hyper Speed mode will only work correctly on the Pro 3 series printers with the Hyper Speed autocalibrator installed. The absence of any of these components may result in printing failure.

The Hyper Speed hotend can also be purchased as part of the Hyper Speed Upgrade Kit.

It should be kept in mind that the Hyper Speed printing mode will only work correctly if the Hyper Speed hotends, the Hyper Speed autocalibrator, and the Hyper Speed filaments are installed on a Pro 3 series printer with the with Hyper Speed mode activated. The absence of any of these components may result in printing failure. The version of the ideaMaker software to be used with the Hyper Speed mode is ideaMaker 4.4.0 Alpha.

Manufacturer Raise3D
Type Direct Hyper Speed
Filament diameter 1.75 mm
Nozzle diameter 0.40 mm
Maximum printing temperature 300 ºC
HS Code 8477.9080

Accessories

30 other products in the same category:

Filament2Print © All rights reserved

DATIVIC S.L. CIF/VAT: ESB70460423

Pol. Ind. Porto do Molle. 7A. 36350 Nigran (Pontevedra - Spain)