Display Nav Left

Language:

-20%

Compare

You must be logged in to manage your wishlist.

Premium HiPS (Polystyrene)

Ref.: HIPS-PRM-BLACK-175-750

31.95 €

-20%

25.56 €

Tax excl.

Diameter

Format

Colour

Quantity

In stock 15 units available for immediate shipping.
units available for shipping in 0 - 0 days Available for shipment within 0 - 0 days

Product temporarily out of stock with these characteristics. Select another combination.

We notify you when it will be available:

Approximate delivery date: Friday 22 November

Available

Returns

Ask about this product

High Impact Polystyrene or HIPS is one of the existing varieties within polystyrenes. Since polystyrene is a very fragile polymer at room temperature, it is modified by the addition of polybutadiene to improve its resistance to impact.

Premium HIPS Filament (High Impact Polystyrene) is a thermoplastic obtained by polymerizing high impact resistance. It is known as "High Impact Polystyrene" and used as support material ABS or PLA prints.

Although most of its mechanical and physical properties (stiffness, tensile strength and impact resistance, thermal stability, ...) are similar to those of ABS, there is a feature that makes it different to everyone else which is its solubility in D-Limonene, allowing to make unworkable forms a soluble support material and will be realized once the piece in D-Limonene and HIPS immerse disappears, leaving the piece without any support material with a high surface quality.

It is indicated for light and high quality technical parts material. Premium HIPS filament is a bit lighter than the ABS, which is why it can be printed at a temperature slightly lower. The temperature is 230C optimal printing. When printed at this temperature it is necessary that the temperature of 90-110 bed is to minimize the warping effect.

Premium HIPS (Polystyrene) filament is resistant to oils, fats and alkalis but not fuel. As for his post-processing and finishing it can be chrome, paint, glue and sand. HIPS supports evil UV rays, so long exposure to sun fade and become brittle him. It has low electrical conductivity, so it can be used as insulation. Its properties typically used in high-frequency. As for the softening temperature HIPS supports up 95ºC.

General information
Material	HiPS
Format	50 g / 750 g
Density	1.04 g/cm³
Filament diameter	1.75 / 2.85 mm
Filament tolerance	± 0.1 mm
Filament length	(Ø 1.75 mm - 0.75 Kg) ± 299 m / (Ø 2.85 mm - 0.75 Kg) ± 113 m

Printing properties
Printing temperature	230 - 235 ºC
Print bed temperature	90 - 110 ºC
Chamber temperature	✗
Cooling fan	✗
Recommended printing speed	- mm/s

Mechanical properties
Charpy impact strength	13 KJ/m²
Elongation at break	20 - 65 %
Tensile strength	25 MPa
Tensile modulus	2250 MPa
Flexural strength	- MPa
Flexural modulus	2250 MPa
Surface hardness	Shore 65 D

Thermal properties
Softening temperature	95 ºC

Specific properties
Transparency	✗

Other
HS Code	3916.9
Spool diameter (outer)	200 mm
Spool diameter (inner hole)	52 mm
Spool width	55 mm

It´s a material with properties very similar to those of ABS that printing is not especially difficult to print. Nozzle temperature should be between 230 and 235 °C. As in the case of ABS, the need to use a hot bed at a temperature of about 110 °C. Once the printing must wait for the piece cool before removing to prevent any deformation may occur due to the printing temperature.