Lay-Fomm 60

To print with the LAY-FOMM 60 filament is not necessary to have a warm bed in the 3D printer. It is essential to use Kapton Tape or 3DLac. For maximum flexibility of the printed object it is recommended that part or object immersed in a container of water from one to four days. The effect of PVA solution component and the other part of the gelatinous transformation begins to be clearly seen after immersed one day. If you want to reduce the time the object immersed in the liquid to print fewer walls (Shell) and less filling percentage. It can also accelerate dissolution of the PVA if shaken occasionally workpiece.

The recommended print temperature is 220 °C to 230 °C. The POROLAY filaments are specially designed for experimental use by experienced users. All components of the filament 60 LAY-FOMM are harmless and safe.

Masterspool format

The 250 g. format of the Lay-Fomm 60 filament can sometimes cause problems during the printing process because it does not include a spool that helps the correct supply of material from the 3D printer.

To avoid this type of problem when printing this and other filaments that are sold in masterspool format you can use a variable spool holder. Thanks to the use of this device, all kinds of tangles and overlaps derived from the absence of a spool are largely avoided.

* The typical values detailed in this table should be considered as a reference. Actual values may vary depending on the 3D printer model used, part design and printing conditions. We recommend confirming the results and final properties with own tests. For more information you should consult the technical data sheet of the product.