Kapton tape 100mm
search
  • Kapton tape 200mm for 3D printer.
  • Kapton tape 100mm
  • Kapton tape 50mm
  • Kapton tape 8mm
Compare
You must be logged in to manage your wishlist.

Kapton Tape

KAPTON-TAPE-100
17.95 € 17.95 €
Tax excl.
Measures (width x length):
Quantity

In stock 48 units available for immediate shipping.
units available for shipping in 0 - 0 days Available for shipment within 0 - 0 days

Product temporarily out of stock with these characteristics. Select another combination.

Product temporarily out of stock with these characteristics. Select another combination.

We notify you when it will be available:

Approximate delivery date: Monday 16 September
Available

Kapton Tape is used to reduce the warping effect 3D printing or thermal and electrical insulation. Also it is known as polyamide tape. In 3D printing is used as printing surface for those filaments that require high temperatures print base bed (ABS, HIPS, PC, etc which require a temperature of bed 80 to 130 °C) because the Kapton Tape resists high temperatures and provides high adhesion between the base and the printed piece.

One of the great advantages is that in the event that the part is strongly adhere to the base, removing the piece Kapton tape itself is also retire without damaging the base with sharp spatulas of 3D printer. (Case commonly produced using lacquers standards).

For large parts that can be susceptible to warping or material effect with high internal forces (Taulman Tritan-BluPrint, Nylons, PC, etc) can be applied on the itself Kapton Tape with layer 3DLac which will help increase the adhesion between base part and thus eliminate the warping effect.


It is also used for mounting 3D printers for isolation of some components thereof.

General information
Manufacturer DuPont

Dimensions and weight
Dimensions Ø 95 mm x 0.6 mm x 33 m x 8 / 50 / 100 / 200 mm

Other
HS Code 4811.4

This Kapton Tape has a great capacity to stick to the printer dock which is necessary to ensure good print quality, but it can become a minor inconvenience at the time of having to place the Kapton Tape on the base since this can creating fold wrinkles or air bubbles after spoil your 3D printed parts. To avoid this we recommend you follow these steps:

  1. Unroll a piece of Kapton tape that is a little longer than your printer dock.
  2. Tape the end of the tape to one side of the print base. Press well on the tape for sticking to the side and then not come loose. It is important that the tape is aligned with the direction of the base, but will not be achieved then cover the entire base.
  3. With the help of a plastic spatula you have to go slowly sticking the tape to the base and without leaving wrinkles or air pockets.
  4. Cut the tape and stick it to the other side of the printer dock.