Timberfill Light Wood Tone

New product

27 Items

36,36 €
36,36 €

Ask for information

Filament of high quality that allows a light wood finish.

Filament Timberfill Light Wood Tone is a filament high quality 3D printing FFF / biodegradable FDM looks like wood (wood powder 100% natural).

The advantage of this material is that it can be easily used in 3D printing, much like the PLA, obtaining a high quality printing even in the difficult details and excellent lamination of the printed object.

Timberfill Light Wood Tone is especially suitable for 3D printing of decorative elements. Since the combination of the new geometries that can be manufactured through 3D printing and the various possibilities of surface finish featuring Timberfill Light Wood Tone allows you to create innovative decorative pieces.

Once the filament Timberfill Light Wood Tone uses in its 3D printers, it is recommended to remove the remaining filament and climb the PLA filament extrusion for one minute at high temperature (230 ° C). This will eliminate shape inside the printhead Timberfill Light Wood Tone any other filament which can cause jams the nozzle. In the councils of use tab, you will find more information about using this thread for your 3D printer and get the best print results you risk spoiling or damage some components.

Timberfill_Fillamentum_EN

Data sheet Timberfill Filament in English

Download (756.17k)

Printing with this filament is not as simple as with other types of plastics. You need to follow a few steps to avoid problems during and after printing.



  1. You need to use a nozzle at least 0.4mm in diameter, although it is best to use a 0.5mm diameter nozzle. Your printer should have the option of heating the base since it needed 40ºC for the phenomenon of "warping" does not occur. In addition to the base you must place Kapton Tape or 3DLac to ensure adhesion between the base and the workpiece.

  2. The filament is easily deformed, so it is advisable that the feeder your 3D printer you reduce the pressure on the filament so there are no excessive marks on the  filament. (It is also recommended print direct drive to prevent facture filament itself because of its delicacy).

  3. The optimum temperature of the extruder may vary between 170 and 185 ° C.

  4. Once you have finished printing, remove the  filament your 3D printer and load PLA filament for about 30 seconds to clear any remaining that may remain within the extruder. If you do this you run the risk that the extruder is locked next time you want to print.



  • Type of material: Wood fibers with polymer

  • Manufactured: Czech Republic. Fillamentum current with the most sophisticated manufacturing technologies

  • Color: Light Wood

  • Transparency: Opaque

  • Diameter: 1.75 mm or 2.85mm

  • Nozzle temperature: 170-185ºC

  • Print base temperature: 40 ° C

  • Net Weight: 750gr

  • Roll diameter: 200 mm

  • Roll width: 50 mm

  • Inside hole diameter: 55 mm

  • Charpy impact strength (+ 23 ° C): 93.4 kJ / m2

  • Diameter tolerance: +/- 0.1mm

  • Elongation at break: 10%

  • Stress at break: 24.5 MPa

  • Nozzle diameter: > 0.4 mm

  • HS Code: 3916.9

5 other products in the same category: