

In 2012 the great filament creator, Kai Parthy, launched in an incredible and innovative Laywoo-3D wood filament. Never before has anyone made a filament containing natural wood, which revolutionized the world of 3D printing. Kai Parthy did it again, picking up that wood filament, adding, according to the German's textual words, "some flexibilizers" to the composition to get the LayWood-Flex.
Laywood-Flex is a filament made from wood fibers (35%), a bonding polymer and another flexibilizer, which recreates a surface finish, texture and flexibility similar to some kind of natural wood.
The pieces made with the Laywood-Flex can be sanded and painted. In addition, if the extrusion temperature changes, the surface color of the piece changes slightly. The lower the extrusion temperature, the lighter color is obtained and if the extrusion temperature is higher, a darker color surface is obtained in the figure. In addition, the temperature also affects the mechanical properties of the filament. In the following graph you can see the difference in load and maximum flexibility it supports with a temperature increase of only 30ºC, with maximum values at 250ºC.
Laywood-Flex is especially suitable for 3D printing of decorative elements. Since the combination of the new geometries that can be manufactured through 3D printing and the various possibilities of surface finish offered by Laywood-Flex will allow you to create innovative decorative pieces.
General information |
|
Material | PLA |
Format | 50 g / 250 g |
Density | - g/cm³ |
Filament diameter | 1.75 / 2.85 mm |
Filament tolerance | ± 0.1 mm |
Filament length | - |
Printing properties |
|
Printing temperature | 180 - 250 ºC |
Print bed temperature | 40 ºC |
Chamber temperature | ✗ |
Cooling fan | ✓ |
Recommended nozzle diameter | Min. 0.4 mm |
Mechanical properties |
|
Elongation at break | - % |
Tensile strength | - MPa |
Tensile modulus | - MPa |
Flexural strength | - MPa |
Flexural modulus | - MPa |
Thermal properties |
|
Softening temperature | - ºC |
Specific properties |
|
Transparency | - |
Other |
|
HS Code | 3916.9 |
Spool diameter (outer) | 200 mm |
Spool diameter (inner hole) | 125 mm |
Spool width | 30 mm |
Once an impression with this filament has been completed, the filament should be removed and the cleaning filament loaded for 30 seconds to eliminate any traces of the wood particles contained in the Laywood-Flex. This way the user avoids jams in future impressions.
The 250 g. format of the LayWood-Flex filament can sometimes cause problems during the printing process because it does not include a spool that helps the correct supply of material from the 3D printer.
To avoid this type of problem when printing this and other filaments that are sold in masterspool format you can use a variable spool holder. Thanks to the use of this device, all kinds of tangles and overlaps derived from the absence of a spool are largely avoided.