Display Nav Left

Language:

-20%

Compare

You must be logged in to manage your wishlist.

PC (Polycarbonate)

Ref.: PC-PRM-175-750

36.90 €

-20%

29.52 €

Tax excl.

Diameter

Format

Quantity

In stock 0 units available for immediate shipping.
units available for shipping in 0 - 0 days Available for shipment within 0 - 0 days

Product temporarily out of stock with these characteristics. Select another combination.

We notify you when it will be available:

Out of Stock

Returns

Ask about this product

Polycarbonate filament (PC) is extremely strong, durable and impact resistant. Today it´s one of the most common thermoplastics in the manufacture of electronics, appliance housings, CDs, toys, etc. One of the biggest barriers PC to the moment when introduced into FDM 3D printing was its high melting point. However with this Polycarbonate filament you can print at a temperature of between 250 and 285ºC that make it accessible for a variety of FDM 3D printers.

PC is a very rigid and resistant thermoplastic with high impact resistance, good fire resistance, which greatly supports contact with oils, greases and solvents with low deformation and withstands temperatures of about 100 °C without deformation. It also presents a good transparency, it is considered a good electrical insulator and holds up well be exposed to weathering and sunlight.

General information
Material	PC
Format	50 g / 750 g
Density	1.20 g/cm³
Filament diameter	1.75 / 2.85 mm
Filament tolerance	± 0.05 mm
Filament length	(Ø 1.75 mm - 0.75 Kg) ± 259 m / (Ø 2.85 mm - 0.75 Kg) ± 98 m

Printing properties
Printing temperature	250 - 285 ºC
Print bed temperature	100 - 110 ºC
Chamber temperature	-
Cooling fan	✗
Recommended printing speed	- mm/s

Mechanical properties
Elongation at break	6 %
Tensile strength	66 MPa
Tensile modulus	2400 MPa
Flexural strength	90 MPa
Flexural modulus	2000 MPa
Surface hardness	-
Impact strength	21 KJ/m²

Thermal properties
Softening temperature	(ISO 306) 145 ºC

Specific properties
Transparency	50 %
Chemical resistance	✓

Other
HS Code	3916.9
Spool diameter (outer)	200 mm
Spool diameter (inner hole)	53 mm
Spool width	54 mm

In too humid environments PC filament may absorb moisture and present problems when printing. These problems can lead to poor quality prints. Therefore it is advisable that the PC filament remains in an airtight bag with a silica bag while it is printing is not possible to avoid contact with moisture.

Optimal print temperature is between 250C and 285C. PC filament has an upper warping effect with respect to the ABS. You need to print it with a bed temperature of 110-130 ºC. It is imperative that you use BuildTak, Kapton Tape or 3DLac so the pieces do not tend to detach from the base. As for the interior temperature which is printed it is recommended to be controlled and there are no drafts.