Nylon Taulman 230

Taulman3D

New product

25 Items

41,95 €
41,95 €

Ask for information

First nylon filament to printing at low temperatures without the need for a hot bed.

Taulman Nylon 230 filament  is the first of the 3D printer filaments Taulman developed, which is designed to printing at low temperature. This filament is printed with a temperature ranging between 225 and 235 ° C.

In addition, to print this filament is not necessary to use hot bed, it can be perfectly printed on a cold bed, on which Blue Tape should be placed. 

Thanks to this Taulman Nylon 230 filament can be used in any 3D printer. Thus, with 230 Taulman Nylon filament makes available to any user of 3D printer the ability to print using heavy-duty piece Nylon Taulman.

In the following article you can see the main differences of nylon Taulman 3D filaments.

Elongation at break (%) 41.7
Tensile strength (MPa) 34
Tensile modulus (MPa) 73
Softening temperature (ºC) 68
Chemical resistance Chemical resistance
Hide color variations (Hide color variations)

Nylon Taulman 230 filament must be used at a temperature between 228 and 235°C. The manufacturer's Taulman recommended temperature is 230ºC. No need to use hot bed, you only have to place a layer of Blue Tape or 3DLac on the bed printing. In case of having warm bed, it is advisable to use a temperature of 45ºC.

In terms of printing speed, Nylon Taulman 230 filament to print at a speed that is 70-80% speed normally use the 3D printer to print with ABS or PLA.

General information
Manufacturer Taulman (USA)
Material Nylon 230
Format Pack of 50 g
Spool of 0.45 kg
Density 1.25 g/cm3
Diameter of filament 1.75 or 2.85 mm
Diameter tolerance ±0,05 mm
Filament length ±149 m (Ø 1.75 mm-0.45Kg)
±56 m (Ø 2.85 mm-0.45Kg)
Color Natural / Clear
RAL/Pantone -
Print settings
Printing temperature 228-235ºC
Print bed temperature Not necessary (Recommended 45ºC)
Chamber temperature Not necessary
Cooling fan Recommended
Mechanical properties
Izod impact strength -
Charpy impact strength -
Elongation at break 417%
Tensile strength 34 MPa
Tensile Modulus 73 MPa
Flexural strength  -
Flexural modulus -
Surface hardness  -
Thermal properties
Softening temperature 68ºC
Melting temperature 195ºC
Specific properties
Transparency  No
FDA certification No
Inflammability (UL 94 HB) Yes 
Additional Information
HS Code 3916.9
Diameter coil (outer) 200 mm 
Diameter coil (inner hole) 50 mm 
Coil Width 50 mm 


* The typical values detailed in this table should be considered as a reference. Actual values may vary depending on the 3D printer model used, part design and printing conditions. We recommend confirming the results and final properties with own tests. For more information you should consult the technical data sheet of the product.

30 other products in the same category: