Find the most suitable 3D printer for your needs.
We guide you to find the best option according to your needs.
Find the most suitable 3D scanner for your needs.
Contact us and we'll get it for you.
Find the most suitable filament for each application.
Find the most suitable resin for each application.
Find the most suitable powder for each application.
Find the most suitable pellets for each application.
Find the accessory you need for your 3D printer.
Find the ideal accessories for your 3D prints.
Do you need more than 1 units? Please, contact us.
Product temporarily out of stock with these characteristics. Select another combination.
We notify you when it will be available:
Bondtech HeatLink
Bondtech's HeatLink system is a set of 50 mm long adapter cables that allow heaters and thermistors with a Molex Microfit 3.0 connector to be connected to virtually any printer.
The HeatLink system currently consists of six different adapters:
HeatLink Molex MX-50-57-9002: This is an adapter with a Molex Microfit 3.0 terminal on one end and a Molex MX-50-57-9002 connector on the other. It allows to connect the Bondtech 300 ºC thermistor to Prusa Mk3/S/+, Mk2.5/S and Mk2/2 printers.
HeatLink Ferrule: This is an adapter with a Molex Microfit 3.0 terminal on one end and two crimp terminals on the other. It allows the Bondtech 50W heater to be connected to multiple Prusa and Creality printers.
HeatLink JST SMP-02V-BC: This is an adapter with a Molex Microfit 3.0 male terminal on one end and a JST SMP-02V-BC connector on the other. It allows to connect both the 300°C thermistor and the Bondtech 50W heater to the Creality Ender 5 printers.
HeatLink JST VHR-2N: This is an adapter with a Molex Microfit 3.0 terminal on one end and a JST VHR-2N connector on the other. It allows the Bondtech 50W heater to be adapted to Creality CR10 series printers.
HeatLink JST XHP-2: This is an adapter with a Molex Microfit 3.0 terminal on one end and a JST XHP-2 connector on the other. It allows the Bondtech 300°C thermistor and 50W heater to be used in multiple Creality printers.
Heatlink JST XH-2 With Lock: This is an adapter with a Molex Microfit 3.0 terminal on one end and a locking JST XH-2 connector on the other. It allows the Bondtech 300°C thermistor to be fitted to some of Creality's CR-10 series printers.
Thanks to the HeatLink system, it is easier to adapt any thermistor to heater with a Molex Microfit 3.0 connector, such as the 300°C thermistor or the 50W heater from Bondtech, in Prusa or Creality printers.
Each Heatlink model includes two connectors: a Molex Microfit 3.0 connector, which will connect to the thermistor or heater cartridge, and another connector that will connect directly to the printer board. Heatlink adapters use standard connectors, so they are compatible with virtually any printer in addition to those listed in the compatibility chart. To find out which HeatLink is suitable for a printer not listed in the table, please check the printer board for the type of connection used.
Please note that the same printer may require different HeatLinks for the thermistor and the heater.
Molex Microfit 3.0 adapter cables to other connectors. Allow Bondtech thermistors and heaters to be used in virtually any printer.