• $options.id_post:
  • $options.slug:
  • https://filament2print.com/gb/blog/_.html
  • es
  • gb
  • pt
  • fr
  • Radial fan

    New product

    13 Items

    6,45 €tax excl.
    7,80 €tax incl.

    Ask for information

    Radial fan is one of the most recommended as a layer fan, an essential element in all 3D printers with which you want to print materials such as PLA or PETG.

    Radial or centrifugal fans are in which the air inlet and outlet pass perpendicularly. The multi-blade crown sucks the air through the central area of the fan and expels it through a duct located at 90° with respect to the inlet. The internal geometry of the radial fan reduces its volume as it approaches the area of air outlet causing an increase in pressure, ideal for cooling a specific area. In addition, when disposing of a multi-blade crown, the ejected flow is totally constant and the noise produced is minimal. Noise that is reduced almost completely thanks to the two bearings embedded in the fan chassis.

    Radial fan 12v 50x50 mm

    Image 1: Radial fan 12v 50x50 mm


    This type of fan is widely used as a layer fan in 3D printers and many users who improve their 3D printer also use it to cool the electronics due to the cooling power that it presents compared to the space it occupies and the power consumption.

    The radial fan has a brushless motor (brushless) to 12v, which means high performance, high precision, speed up to 6500 rpm and with a long service life even using this fan 24 hours a day .

    The radial fan housing is made of PBT (Polybutylene terephthalate) with 30% glass fiber being a material with more than enough properties to support the actions caused by the 3D printer and its environment.

    Radial fan 12v

    Image 2: Radial fan 12v


    There are other types of fans also widely used in 3D printersaxial fans. These fans are used to cool the electronics, in the heat sink of the HotEnd and even in some cases as a layer fan. In the axial fans the air enters and leaves parallel to the axis of the propeller, being able to move a lot of flow with a relatively low pressure.

    Axial fans

    Image 3: Axial fans


    This radial fan incorporates a JST XH2.54 2P connector with a 28 cm long cable to facilitate connection with any 3D printer.

    JST XH2.54 2P connector

    Image 4: JST XH2.54 2P connector

    Before purchasing an axial fan, the user must check the measurements and voltage used by his 3D printer. The usual measurement is 50x50x15mm and the most common voltage are 12v, although there are 3D printers on the market that also use 24v.

    • Manufacturer: Jiesammy
    • Models: 5010.
    • Dimensions: 50x50x10mm.
    • Input Type: 12v or 24v.
    • Connector Type: JST XH2.54 2P
    • Cable length: 280mm.

    Radial fan 50x50 for 3D printer

    Image 3: 5010 Model

    JST XH2.54 2P connector for 3D printer

    Image 4: JST XH2.54 2P conector

    14 other products in the same category: