Kit 25kg of natural PLA Pellets + Masterbatch

Pellet-PLA

New product

319,00 €
319,00 €

Ask for information

Natural PLA pellets for use with an extruder filament (Filastruder) for making filaments for 3D printing.

Using natural PLA pellets you can make filament for your 3D printer using an extruder Filastruder or any other filament. The kit contains a 25 kg bag of pellets PLA and the corresponding dye. There are available the following colors: white, black, yellow, red and blue. In the comments area of ​​the shopping cart you can tell us what color or colors you want.

The combination of the pellets PLA, dyes Filastruder and recommended for PLA will allow you to make your 3D printer filament for on demand in your own home and with the color you want. This is a great advantage, especially when making small series of parts in a given color. Since in some cases it may be difficult to find the exact color is needed for a given impression. These pellets are high quality PLA, so good extruder using a filament as the filament Filastruder can get for your 3D printer with similar qualities to the filament commercial PLA.

Here's recommended to use these pellets PLA in the Filastruder parameters. For best results with any other filament extruder, we recommend you read the manufacturer's advice to extrude PLA. The temperature suitable for extruding these pellets in Filastruder PLA is between 220 and 230C. For higher speeds can be increased extrusion temperature to 240 ° C, but in this case the risk of the filament smart air bubbles appear is run.

It is very important to keep the pellets PLA inside a Ziploc bag, to prevent acquiring humidity before use. Since pellets have moisture if the filament is manufactured may contain small imperfections. Once the filament manufactured using pellets PLA, it is also highly recommended that you keep this filament in a dry place, or in a resealable bag. Thus you will prevent the filament from absorbing moisture, thus obtaining better results in 3D printing.

Delivery time can range about 15 or 20 days depending on availability.

The temperature suitable for extruding these pellets in Filastruder ABS is between 220 and 230C. For higher speeds can be increased extrusion temperature to 240 ° C, but in this case the risk of the filament rocks smart air bubbles appear is run.


  • Type of plastic: ABS

  • Color: Natural

  • Transparence: Opaque

  • Quantity: 25 Kg

  • MFR rate: 28g/10min @ 220°C/10.0Kg

  • Weight for shipping: 27Kg

6 other products in the same category: