3DLac

3DLac

New product

30 Items

5,75 €
5,75 €

It is the only 3DLac lacquer specially created for 3D printing in order to reduce the warping effect.

3DLac is the only lacquer created especially for 3D printing. Especially for 3D printers feature 'Heated Bed' or "heated bed." 3DLac function is to hold the first layer of plastic so that it does not move at the start of printing, preventing unwanted failures in the early 3D printing process.

All users who prefer use lacquer and not  Kapton Tape, can be achieved with a vaporized light on the glass bed base that the first plastic layer is fixed completely to this base bed. 3DLac properties make the base while the extruded plastic head is hot to adhere strongly. Upon cooling, the printed piece is released smoothly and undamaged. Specially designed for FDM 3D printing and high demands, 3DLac has a very strong adhesion to 100-110 °C.

3DLac has been developed by Leon3D with the advice of Belloch laboratories with more than 50 years of experience in the manufacture of lacquers. Its new formula unscented double locking is perfect for holding and removing the piece once printing is complete. No hits, subject only. A revolutionary lacquer that will mark a before and after among users of 3D printing.

With 3DLac parts are strongly adhered to the base bed. It is also very easy to clean with a damp cloth is sufficient. Thanks to 3DLac dramatically reduces the warping effect. The power of Accession 3DLac is so great that it is not necessary to vaporize every print. Normally the base with 3DLac every 3-4 impressions bed is sprayed, representing incredible cost savings over other coating materials not specifically designed for 3D printing.

In the following video you can observe the operation of 3DLac:

Remove the tray (glass) of 3D printer. Clean the glass or tray so that it is completely smooth before applying 3DLac. 3DLac spray over the entire surface of the glass tray or about 20 cm away (important always do it out of the printer in order not to obstruct any parts thereof). After printing a single piece re-spraying 3DLac right in the area of the piece it is finished printing, the rest of the surface with spray every 3-4 prints is enough. When making impressions 3-4 should be re-clean the motherboard 3DLac and re-lacquer spray again.


After the printing, wait until the heated base is below 30 °C, the adhesion will be lighter and without tools (depending on the characteristics and dimensions of the part) may remove the piece gently and without damage.


  • Content: 400mL

  • Manufacturer: Leon3D / Belloch laboratory in Spain

  • Components:


-Isopropyl Alcohol
-Methylal
-Isobutane
-Propane
-Copolymer VP / VA
-Alcohol denat
-Parfum (benzyl alcohol, benzyl salicylate, coumarin, geraniol, Butylphenyl Methylpropional, linalool, benzyl benzoate, citronellol, Alphaisomethylionone, Hydroxycitronellal, amyl cinnamal).

15 other products in the same category: